Turning The Camera On And Off - LEXIBOOK DJ025SP Mode D'emploi

Appareil photo numérique

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Note:

- If the CD does not auto run, click Start Run, type in "D:\setup.exe" in the

Run dialog text box (where D:\ is your CD-ROM drive) and press Enter.

- Please wait between the installations processes of the software and the

camera driver (the installation program may take up to 1 minute before

starting).

- You must install the driver before downloading pictures from the camera.

- Make sure the camera is not connected to your PC before installing the

driver and the software.

Press the Power button (8) for about 3 seconds to turn the camera on. The

camera will sound a beep to confirm that it is ready for use. Press and hold

Power button (8) for about 3 seconds again to turn it off.

Note: The camera will auto power off after 60 seconds of inactivity.

There are 2 resolution modes:

1. Press the Menu button (8) three times to see what kind of resolution setting is

selected on your camera.

2. Press the Shutter button (1) once within 3 seconds to change the resolution.

3. Repeat steps 1 and 2 to modify the resolution again.

Switch on the camera.

A Auto Flash

1. Press the Menu button (8) until the

corner of the LCD screen. Press the Shutter button (1) within 3 seconds to

confirm and activate the auto flash.

Flash on

2. Press the Menu button (8) until the

corner of the LCD screen. Press the Shutter button (1) within 3 seconds to

confirm and switch on the flash.

3. Press the Menu button (8) until the

corner of the LCD screen. Press the Shutter button (1) within 3 seconds to

confirm and switch off the flash.

DJ025SP_02IM0278.indd 10