Temperature Indication; Temperature And Humidity - TFA TWIN Plus Mode D'emploi

TFA_No_30.3049_Anleitung_05_17
TWIN PLUS – Wireless Thermo-Hygrometer
C: Housing:
C 1: Wall mount hole
C 2: Battery compartment
C 3: Stand (fold out)
5.2 Outdoor transmitter (Fig. 2):
D 1: Transmission signal lamp
D 2: Display of temperature and humidity
Buttons inside the battery compartment
D 3: RESET button
D 4: °C/°F button
Housing:
D 5: Wall mount hole
D 6: Battery compartment
D 7: Stand (fold out)
6. Getting started
Insert batteries:
• Place both instruments on a desk with a distance of approxi-
mately 1.5 meter. Check that no other electronic devices are
close.
• Open the battery compartment of the transmitter by pulling the
battery compartment cover downwards (see marking) and lift up
the cover.
• Insert two new batteries 1,5 V AAA, ensure battery polarities are
correct.
• Close the battery compartment again.
• Open the battery compartment of the basic unit and insert two
new batteries 1,5 V AAA, ensure battery polarities are correct.
• A brief beep tone will sound and all LCD segments will light up
for a short moment.
• Close the battery compartment again.
• The indoor temperature and humidity appear in the display.
Reception of the outdoor values
• After the batteries are inserted the outdoor temperature and
humidity will automatically be transmitted to the basic unit.
16
17.05.2017 10:16 Uhr Seite 9
TWIN PLUS – Wireless Thermo-Hygrometer
• The reception signal-symbol flashes. The basic unit will scan for
3 minutes the outdoor values.
• To toggle to the display of the outdoor temperature and humidi-
ty press the SEARCH/IN/OUT button in normal mode.
• If the reception of outdoor temperature and humidity fails, "- -.-
" appears on the display. Check the batteries and try it again.
Check if there is any source of interference.
• Manual initialization can be helpful. Press and hold SEARCH/
IN/OUT button of the basic unit for 3 seconds in outdoor mode.
• A brief beep tone will sound, "- -.-" and the reception symbol
flash on the display. The basic unit will scan the outdoor values.
7. Operation
• The instrument will automatically quit the setting mode if no
button is pressed within 15 seconds.
• Every press of a button is confirmed with a short beep.
7.1 Store and reset of the maximum and minimum values
• As soon as the basic unit and the outdoor transmitter are active
the maximum and minimum values for indoor and outdoor will
be stored and reset automatically after 24 hours.
• Press and hold SEARCH/IN/OUT button for 3 seconds in the
outdoor mode to clear the maximum and minimum outdoor val-
ues manually. At the same time the reception for the outdoor
transmitter will be activated.
• Press the RESET button with a pointed pin or remove the batter-
ies to clear all recorded values.

7.2 Temperature indication

• Press the ▼/°C/°F button at the backside of the basic unit in
normal mode to change between °C (Celsius) or °F (Fahrenheit)
as temperature unit.

7.3 Temperature and humidity

• The display shows the current indoor temperature and the
humidity, the comfort level and the maximum and minimum val-
ues for the past 24 hours.
• Press the SEARCH/IN/OUT button.
17