Celestron TetraView Guide De Démarrage Rapide page 3

SPECIFICATIONS
Stage Mechanical Stage 3.5 in x 3.5 in (88 mm x 88 mm)
5 MP 1/2.5" CMOS; 10x Magnifi cation in lieu of an eyepiece
Digital Camera
LCD Monitor 4.3 in. (109 mm) TFT LCD touch screen with 4x digital zoom —
Touch digital TFT display
Resolution — 480 x 272 pixels
Focuser Dual — Coarse/Fine
Objectives Achromatic, glass type — 4x, 10x 20x, 40x
Memory 8 GB SD card (approximately 2200+ snapshots @ 5 MP)
LCD Rotation 180° – 90° left / 90° right
Filter Wheel Red/Green/Blue/1 mm hole/3 mm hole/6 mm hole (default)
Nosepiece Quad with click stop
Illuminator Built-in electric — LED 6 Volt and 6 Watt
Condenser N.A. 0.65
AC Adapter Input Universal 100 to 240 Volt 50/60HZ
Batteries User supplied 4 AA — (optional - up to 3 hours usage)
Weight/Dimensions 67 oz/1.9 kg 7.0" (178 mm) x 5.5 in (140 mm) x 13.0 in (330 mm)
SETTING UP YOUR MICROSCOPE
1. Carefully remove the microscope and other parts
from the carton and set them on a table, desk, or
other fl at surface.
2. Remove the plastic cover from the microscope.
3. Plug the small cable from the AC adapter into the
socket on the back of the base
(see Figure 2).
4. Insert the plug you need (see note below) into the
AC adapter and then plug the adapter into the proper power source.
NOTE: The AC Adapter supplied with this microscope has an interchangeable plug system that can work in the
USA, UK, Europe, Australia, and many other parts of the world.
You can easily change plugs for your particular power requirement:
A. You may have one of two different types of adapters. One is shown in
Figure 3A and another one is somewhat similar shown in Figure 3B. Each
has a different means of changing plugs.
B. For the Figure 3A type, push down on the small button labeled "PUSH"
and hold it down while at the same time holding the prongs of the plug.
Rotate it slightly counterclockwise and pull up to remove it. Then release
the "PUSH" button down.
Product design and specifi cations are subject to change without prior notifi cation. This product is designed and intended for use by those 14 years of age and older.
© 2019 Celestron • All rights reserved • celestron.com/pages/technical-support • 2835 Columbia Street • Torrance, CA 90503 USA • 11-19
celestron.com/support/warranties
MAGNIFICATION (POWER) MAGNIFICATION (POWER)
Use the following table to determine the magnifi cation Use the following table to determine the magnifi cation
of the different objective lenses in combination with of the different objective lenses in combination with
your microscope using the normal mode of the digital your microscope using the normal mode of the digital
image on the LCD screen and using the digital zoom image on the LCD screen and using the digital zoom
feature. feature.
Objective Lens Objective Lens Objective Lens
Digital Image Digital Image Digital Image
Maximum with 4x Maximum with 4x
digital zoom feature digital zoom feature digital zoom feature
WORKING DISTANCE WORKING DISTANCE
Objective Lens Objective Lens Objective Lens
Working Working
Distance (mm) - est. Distance (mm) - est. Distance (mm) - est.
TOUCH PEN
You can keep the touch pen handy in
the receptable behind the Power ON/OFF button.
Take the plug style that you want to use and
center it over the AC adapter and rotate
it until it falls into the opening. Rotate it
clockwise until you hear a click, which lets
you know the plug is installed correctly.
Fig 2
C. For the Figure 3B type, pull the plug up and away
while holding the base of the AC adapter. The plug
will come off. Take the plug style that you want to
use and align the two holes in the bottom of the plug
with the two pins in the AC adapter. Then, push the
plug into the AC adapter all the way.
Battery Operation — You can use your microscope
without AC power if you choose. This gives you the
freedom to operate the microscope outdoors or indoors
anywhere you please. You'll need 4 AA batteries (user
supplied). Open the battery door on the bottom of the
microscope and insert the batteries according to the
battery polarity shown in the battery compartment
(Figure 4). After the batteries are installed, close the
battery door. Battery life will typically be three hours.
4x 4x 4x 10x 10x 10x 20x 20x 20x 40x 40x 40x
40x 100x 200x 400x 40x 100x 200x 400x 40x 100x 200x 400x
160x 400x 800x 1600x 160x 400x 800x 1600x 160x 400x 800x 1600x
4x 4x 4x 10x 10x 10x 20x 20x 20x 40x 40x 40x
35.3 7.8 35.3 7.8 35.3 7.8 1.9 1.9 1.9 0.7 0.7 0.7
ON/OFF Button
Touch Pen
Fig 3A
Fig 3B
Fig 4
ENGLISH |
3