NTech Skywatch Eole Meteos Mode D'emploi

Owner's Instructions
Mode d'emploi
Bedienungsanleitung
Manual de instrucciones
Libretto d'instruzioni
You have just acquired a piece of high precision
equipment which has been created using the most
modern technology. It has been designed to stand
up to intensive use. However, in order to maintain its
appearance and its precision, we recommend that
you treat it with care and read this manual carefully.
Function of the buttons
ON : press for 1 second
OFF : press for 2 seconds (not auto off)
LIGHT : press on and off briefly
UP : setting mode
START / STOP : chronometer mode
DOWN : setting mode
LAP / RESET : chronometer mode
SET / CAL : setting mode
RESET MEMORY : press for 3 seconds
+
Configuration
To access the configuration mode of your instrument,
just press on the button. Pressing the
again cause the system to confirm the setting if there
has been a change. If not then it goes to the next
setting. To modify the settings the
have to be used. Here is how to proceed with the
different instrument settings.
Wind measuring unit (
The units to be selected are : knots, km/h, m/s, fps and
bft. Once the unit is chosen, it remains displayed in
the top right. If no other unit is chosen the instrument
is set to the Beaufort.
Temperature measurement unit (
The units to be selected are : °F, °C, °F
Setting the time of the average (
The times to be selected are : --- (weighting), 3'', 6'',
12'', 30'', 1', 6', 30', 1:00', 6:00', 12:00', 24:00' or timer .
The timer mode allows measurement of the average
between start (press ) and stop (press ), this time
is displayed on the lower lines. This timer allows the
use of the LapTime function (press
flashes). The button also allows the timer to be reset
to zero. This works in the same way as a standard
chronometer.
Setting of the wind and temperature displays (
The displays to be selected are : ---, MIN, AV, MAX.
If AV is selected, the average of temperature and wind
are shown. The display of average values is always
made simultaneously for the wind (at the centre) and
temperature (at the bottom). The other modes (---,
MIN, MAX) only concern the temperature.
Setting of the display is not possible if the units
selected are °F or °C
Measuring the wind
Important : the protective cap has to be removed
from the instrument in order to rotate the impeller.
The impeller has a maximum sensitivity in the
vertical position (due to its magnetic levitation), and
an optimised precision when its axis of rotation is
perpendicular to the wind direction.
button once
and buttons
+ )
)
and °C
+ )
, the symbol
.
In
M
Th
th
of
du
Av
Th
av
Th
M
In
Im
af
gr
tim
is
W
As
po
Bu
pa
te
te
ha
te
ca
te
te
cy
th
ch
M
Th
va
Th
.
of
of
Te
› S
› T
t
› A
i
› A
› T
› T
)
› P
B
o
t
› W
› D
› W
W
Yo
m
EL
Th
in
Th
m
su
tra
sh
th