CBE PT652 Instructions D'emploi page 4

GB
GB
SPECIFICATIONS
12V digital test panel with microprocessor for the control of the voltage (Ref.1) and of the current consumed and
supplied by the leisure battery (Ref. 2).
To turn on the backlight, lightly touch the "touch" button (Ref.3) once, the backlight will remain on for 15 seconds.
To view the values, press 1 time lightly on the touch button (Ref. 3), the values will remain on the screen for
15 seconds.
In case some parts of the 12V equipment (lights, water pump, ...) are switched on at the same time of a charging
device (battery charger, solar panel, ...) the displayed value is the difference between the two currents.
E.g.: connected battery charger:
switched on 12V equipment: 3A (consumption)
displayed value:
Amperometer maximum capacity 130A.
NB:
When the backlight is off the system draws 0.023 A.
CONNECTIONS
- Remove the original cable from the leisure battery negative pole
- Connect the SHUNT to the leisure battery negative pole
- Connect the cable with 3A fuse to the leisure battery
battery).
- Connect the PT 652 test panel to the amperometer using the supplied cable (L=5m) (Ref.A).
Attention:
Pressing too hard to the "touch" button (Ref.3) can cause temporary marks on the display.
4A (charge)
1A (charge)
Connect only to the leisure battery.
and connect it to the SHUNT free bolt.
using the supplied cable (L=0.5m) (Ref.B).
pole (the fuse shall be placed as close as possible to the