To Install The Drive - Pioneer LaserMemory DR-U16S Mode D'emploi

TO INSTALL THE DRIVE

P H
O N
÷ Switch off the power of the personal computer and remove the cover or the front panel.
÷ Remove the blank panel installed at the front of the 5.25 inch slot.
Installation is not possible when there is no empty slot.
÷ Install the fixation slide rails on the drive. (If slide rails are required, contact the shop where you bought
the computer or the computer manufacturer.)
÷ Insert the drive into the slot.
÷ If fixing is required, fix the drive according to the instruction manual for the computer.
Use mounting screws with a length of 5 mm or less.
Use of long screws may damage the drive.
Install the drive after the power supply of the personal computer has been switched
off.
When the mounting screws are loose etc., the vibrations from disc rotation can generate
a ripping noise, so that the screws should be tightened securely.
The drive installation method differs according to the computer type. For details, please
refer to the manuals of your computer.
C
D
-R
O
M
D
R IV
E
E S
B U
S Y
Fig.3
15
<DRC1087>
En