Maintenance And Cleaning - Fritel IP 1266 Mode D'emploi

Timer function
•
To select the timer function, press the "MODE" button until the timer LED lights up. You can now use the rotary knob
to set the desired cooking time, ranging from 1 minute to a maximum of 3 hours. The timer is activated as soon as you
do not touch any button for a few seconds. When the timer runs out, you will hear a short beep and the appliance will
go back into standby mode. You can also see this by the flashing "----" on the display. It is perfectly normal for the fan
to continue working in standby mode.
•
If the setting is not changed for 3 seconds after the LED display has blinked, the last setting chosen is always applied.
The display will alternately show the selected temperature and remaining cooking time or the selected power level
and remaining cooking time.
•
If you do not wish to use a timer, the appliance will automatically switch to standby mode after 2 hours.
•
If you wish to stop the cooking process earlier without using a timer, you can simply switch the appliance off using the
ON/OFF key.

5. MAINTENANCE AND CLEANING

•
First switch off the appliance and remove the plug from the socket.
•
You can clean the cooking plate with a soft, damp cloth or sponge. If the cooking plate is very dirty, you can use a
special cleaner for ceramic cooking plates.
•
The rest of the appliance can be cleaned with a soft, damp cloth. The appliance should NEVER be immersed in water.
Always alllow to dry completely.
•
Remove any dust in the air inlet and outlet with a cotton swab.
6. PRACTICAL TIPS IN CASE OF MALFUNCTIONS
Possible error messages
Error message
A sound signal and the MODE
button does not react.
There is no pot on the cooking
plate.
E01
Indicates a short circuit.
E02
The temperature sensor under
the glass is overheated or
malfunctioning.
E03
The mains voltage is lower or
higher than that displayed on
the unit.
If there is still a malfunction, do not use the appliance. Please address to your sales point. Also when the power cord is
damaged, address to your sales point or recognized repairer.
THE APPLIANCE HAS BEEN DESIGNED FOR DOMESTIC USE. THE WARRANTY CONDITIONS EXPIRE UPON
PROFESSIONAL USE. DEFECTS AND/OF DAMAGES FOLLOWING TO THE NON OBSERVANCE OF THE
USER MANUAL ARE NOT COVERED BY THE WARRANTY.
We are entitled to make technical modifications at all times.
Place a suitable cooking pot in the centre of the cooking zone.
Unplug the power cord, wait a few minutes and try again. If the error persists,
contact your sales point or recognized repairer.
Remove the plug from the socket and allow the cooking plate to cool down. If the
appliance cannot be switched on again, contact your sales point or recognized
repairer.
Check whether your appliance is suitable for the mains.
16
Advice