Antenna Installation - Kenwood CX-DAB1 Manuel D'installation

Determining the antenna installation location
When installing the antenna on the left side
Front pillar
Earth sheet
Amplifier B
Where the earth sheet of Amplifier B can be pasted on the metal part of the front pillar.
1
• *

Antenna Installation

Check the installation location.
1
Wipe the area where antenna film A,
2
amplifier unit B, and earth sheet are
pasted with the included cleaner D.
The coating on the metal surface need not
be removed.
■
Wait until the glass surface is completely
dry before pasting.
■
If the glass surface is cold, such as during
winter, warm it with defroster or dryer.
Remove the separator (tag I) of antenna
3
film A horizontally and paste the
antenna on the front glass.
■
Remove the separator gently.
■
Do not touch the pasting surface
(adhesive side) of the antenna film A.
Remove the separator (tag II) of
4
antenna film A vertically and paste
the antenna gently while applying
pressure.
4
|
English
150 mm
1
70 mm *
Antenna film A
When installing the antenna on the right
side
Amplifier B
150 mm
Antenna film A
After pasting, rub the element in the
5
glass surface in the direction of the
arrow shown in the figure to bond it.
Remove the application film (tag III).
6
■
Do not touch the feeder terminal of the
element. Also, do not apply any glass
cleaner.
Earth sheet
70 mm * 1
Feeder terminal