Time Display - LENCO PMX-300 Mode D'emploi

FUNCTION OF USB READER
USB interface
This unit has two USB jacks. Press the INPUT A key to select USB A, then you can insert a USB stick to play
music. Press the INPUT B key to select USB B, then you can insert another USB stick to play music.
Important: The USB port is intended for data transfer only; other devices cannot be used with this USB
connection. The use of USB extension cords is not recommended.

TIME DISPLAY

In USB mode, the display can show either the elapsed or the remaining time.
With long press of the play/pause key, you can select negative or positive display of the time.
CHARGING THE BATTERY
1. When in battery powered mode, the standby operation cannot be used.
2. The control panel has a charging light. When the battery is charged enough, the light is green.
When the battery is low, the system display prompts 'LOW POWER' and the light turns red.
TO PROTECT THE LIFETIME OF THE INTERNAL BATTERY:
When the battery is empty, switch immediately the POWER knob on the backside to OFF position to
protect the lifetime of the internal battery or to AC to charge it again.
Important: The supplier is not responsible for damage caused by misuse of the device and the battery will
not be covered by the guarantee.
BATTERY DISASSEMBLY
1. Remove the screws on the rear panel.
2. Take out the battery.
3. Disconnect the battery
Remote control
Instruction Manual
Wireless Microphone
AC power cable
11
OPERATING
ACCESSORIES
1 pc
1 pc
1 pc
1 pc