König Electronic VID-TRANS220KN Mode D'emploi page 3

Connection:
Transmitter VID-TRANS220KN
1) Connect an audio source with the RCA
plugs to the audio input (1 and 2) or a
3,5mm plug to the audio input (2).
Note: it's not possible to use both inputs at
the same time.
2) Plug the DC power adapter plug into the
power input (5). Plug the adapter AC
power plug into a wall outlet.
Transmitter VID-TRANS230KN
Plug the USB transmitter into a free USB port of the notebook or PC.
Note: The LED of the (USB) transmitter on the VID-TRANS230KN will be flashing during
transmission. If during transmission the transmitter is pulled out and plugged in again, it's
possible that the music program on the notebook or PC needs to be restarted again to
restart transmission.
Receiver VID-TRANS220KN and VID-TRANS230KN
1) Connect the receiver with the RCA output (1 and 2) to an audio input of an audio system
or amplifier. It's also possible to use the 3.5mm output (3) to connect the receiver to an
audio input of an audio system or amplifier.
Audio
Audio In
Line- In
3
CD
or
PC
MP3