Alarms - Dexton C-11-213035 Notice D'utilisation

2.8. Alarms

Any alarm that is activated : - immediately displayed on the screen.
Any alarm that is activated :
Any alarm that is activated :
Message Fault
displayed detected
Production
A1
anomaly
Short-
circuiting
A2
of the
equipment
ACTIVATING/DISABLING ALARM A1 :
I
Alarm A1 is disabled by default.
1) Press and hold down the bottom key, until the message In is displayed.
2) Press the top key x times, until the message AL is displayed.
3) Press the bottom key (one of the following displays will flash.
4) Using the top key, move to position On to activate alarm A1
5) To confirm, press the bottom key : the display freezes for a moment.
→ Alarm A2 is always activated and cannot be disabled.
- automatically and instantly stops production.
- manually dismissed pressing and holding down the bottom key.
Cause
Check that the pipe at cell level is completely filled with water, and
Low water
the flow is sufficient.
- Check the salt levels in the pool using a recent testing kit.
Low salt - Top up the salt, if necessary, so as to achieve a salt content of 5
- Check that the electrical connections to the terminals of the cell
- Check that the cell's power cable connector is correctly
Problem in the cell
- Check that the cell is not scaled.
- As a last resort, replace the cell.
Problem in the
Contact a professional to repair the electronics unit
electronics unit
- Check that the electrical connections to the terminals of the cell
Problem in the cell
- Check that the cell's power cable is in good condition.
- As a last resort, replace the cell.
Problem in the
Contact a professional to repair the electronics unit
electronics unit
or to oF to disable alarm A1.
Checks and solutions
kg/m3.
are sufficiently tight and not oxidised.
connected to the electronics unit.
are sufficiently tight and not oxidised.
6