Installation - Erie Maxima MAX-CS Instructions D'installation Et D'emploi

PREPARATION BRINE CABINET
Picture 1&10
To facilitate the installation, you may want to remove the salt
lid and main cover from the brine cabinet.
INLET & OUTLET

In case of high concentration of impurities in the inlet
water, we recommend the installation of a sediment filter,
ahead of the appliance.

We strongly recommend the use of flexible hoses to
connect the appliance to the water distribution system; use
hoses with a large diameter in order to limit the pressure
loss.

If the appliance is not equipped with the factory bypass
(optional), we strongly recommend to install a 3-valve
bypass system (not included with this product!) to isolate the
appliance from the water distribution system in case of
repairs. It allows to turn off the water to the appliance, while
maintaining (untreated) water supply to the user.
WITH FACTORY BYPASS (optional)
Picture 2
 = mains water supply (untreated water)
❖ = inlet of appliance (untreated water)
 = outlet of appliance (treated water)
 = house/application (treated water)
1. Screw the factory bypass onto the elbow connections of
the appliance (❖&); make sure to install the gasket
seals. Tighten the nuts firmly by hand.
2. Screw the connection kit with nuts onto the factory
bypass (&); make sure to install the gasket seals.
Tighten the nuts firmly by hand.
3. Connect the mains water supply to the adaptor on the
inlet port of the factory bypass ().
4. Connect the house/application to the adaptor on the
outlet port of the factory bypass ().
WITH 3-VALVE BYPASS SYSTEM (not included)
Picture 3
 = inlet of appliance (untreated water)
❖ = outlet of appliance (treated water)
1. Install the 3-valve bypass system.
2. Screw the connection kit with nuts onto the elbow
connections of the appliance (&❖); make sure to install
the gasket seals. Tighten the nuts firmly by hand.
3. Connect the 3-valve bypass system to the adaptors on the
in () and out (❖) elbow connections.
4. Connect the mains water supply to the inlet of the 3-valve
bypass system.
5. Connect the house/application to the outlet of the 3-valve
bypass system.
EN - English

INSTALLATION


We recommend the use of a stand pipe with P-trap.

To prevent backflow from the sewerage system into the
appliance, always use a drain adaptor with air gap
(optional), to connect the drain hoses to the sewerage
system.

Always use separate drain hoses for the control valve
(discharge of rinse water) and the brine cabinet's overflow.

Lay-out the drain hoses in such a way that pressure loss
is minimized; avoid kinks and unnecessary elevations.

Make sure that the sewerage system is suitable for the
rinse water flow rate of the appliance.
Picture 4
1. Install a drain adaptor with air gap (optional) to the
sewerage system. Ensure a permanent and watertight
connection.
2. Connect a 13 mm hose (optional) to the drain solenoid of
the control valve (); secure it by means of a clamp.
3. Run the drain hose to the drain adaptor and connect it;
secure it by means of a clamp. This drain line operates
under pressure, so it may be installed higher than the
appliance.
4. Connect a 13 mm hose (optional) to the brine cabinet
overflow elbow; secure it by means of a clamp.
5. Run the drain hose to the drain adaptor and connect it;
secure it by means of a clamp. This drain line does NOT
operate under pressure, so it may NOT be installed higher
than the appliance.
Page 6
DRAIN