Safety Precautions - König Electronic HAV-TT25USB Mode D'emploi

7. Record using Audacity software
1. Connect the turntable to your pc via the supplied USB cable.
2. Install the Audacity software and follow the steps shown on the screen.
3. Open the Audacity software by double clinking it's icon.
4. Click "edit" and select "preferences".
5. Select the recording device under the Audio I/O table: "Microphone (USB Audio CODEC)".
Select 2 channels "stereo" and tick the checkboxes below "Channels".
6. Adjust the output and input volume.
7. Place a record on the turntable and start playback.
8. Click the RECORD button to start recording.
9. At the end of the song press STOP in Audacity, then lift and move the tone arm to the tone arm rest.
Move the cursor to the wave area and left click at the end of the song.
10. For the next song, replace the album or move tone arm to another desired song. Immediately press
the RECORD button on Audacity and the recording will continue and other R/L tracks will appear in the
interface.
11. Repeat steps 9 and 10 until all desired tracks have been recorded.
12. To save the tracks, first select "Preferences", select the "File Formats" tab and click on the "Find Library"
button. Select "Yes" and select the location of the "lame_enc.dll" file, (available on the driver cd).
Optionally you can choose to copy the file to your HDD.
13. Highlight the track you want to save by left clicking, holding, and dragging over the waveform in the
display. Release the mouse when the whole track you wish to save is highlighted.
14. Click file and select "Export selection as MP", fill in the file name and select a location to save. After
finishing the first track repeat step 13 for all the tracks you wish to save.

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products should
not be mixed with general household waste. There is a separate collections system for these products.
To reduce risk of electric shock, this product should ONLY be opened
by an authorized technician when service is required. Disconnect the
product from mains and other equipment if a problem should occur.
Do not expose the product to water or moisture.
3