Polar DB950 Mode D'emploi page 4

UK
Installation
Note: If the appliance has
been stored or moved in a
non-vertical position, stand
it in an upright position for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning, maintain a distance of 20cm
(7 inches) between the appliance and walls or
other objects for ventilation. NEVER LOCATE
NEXT TO OR NEAR A HEAT SOURCE.
Note: Before using the appliance for the first
time, clean the shelves and interior with
soapy water.
Maximum load of shelves
DB950
DB951
DB952
Operation
Control Panel
4
DB950_DB951_DB952_ML_A5_v2_20190826.indb 4
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to the mains power
supply.
3. To switch refrigeration system on or off press
26kg
and hold
35kg
4. Press the light button
40kg
or Off as required.
Adjusting the Temperature
1. Press
temperature on the LCD display will flash.
2. Press up button
change the set temperature.
3. Wait 6 seconds for the set temperature to be
stored.
Manual Defrost
1. To start manual defrosting press and hold the
defrost button
2. Press and hold
Display
Note: You can shortly press
•
evaporator temperature.
Manual Demist
1. To start demisting press and hold the demist
button
2. Press and hold
Control Buttons
Manual Defrost button
Down Button
On/Off button
Demist button
Up Button
Light button
for 3 seconds.
to turn the light On
button for 1 second. The set
or down button
for 3 seconds.
for 3 seconds again to stop.
to check the
for 3 seconds.
for 3 seconds again to stop.
to
2019/8/26 14:42