FITFIU FITNESS TREKKING Manuel D'utilisation page 54

STEP 2. Place the front wheel axle between the front fork (6) and fit the brake disc between the brake pads located
on the left side (7), once installed place the wheel pin through its axle and adjust it by screwing on both sides and
closing the lever (8).
6
STEP 3. Slide the saddle into the post (9) and secure it at the desired height by closing the seat (10).
9
STEP 4. Remove the screw and silver washer from the front of the fork (11). Align the holes and insert the screw
through the front mudguard and front light with the fork hole and secure them by tightening the nut with the supplied
tool (12).
11
STEP 5. Put on the rear mudguard. Align the metal part with the sides of the mudguard (13) and tighten the side star
screws (14), remove the silver screw on the back of the electric bicycle frame. Align the upper hole of the mudguard
and adjust it to the frame using the Allen screw (15).
13
7
10
12
14
54
8
15