Product Description; Cleaning And Maintenance - LifeAir IonFlow Signature Mode D'emploi

ENGLISH
IonFlow 500, Signature & Evolution:
1 ion generator (above= 3 corona needles, below=outlet and metal hook)
1 particle collector
1 acrylic stand
1 switch
1 transformer
4 decorative lights
1 protective guard (32 slats and 2 assembly rings)
1 corona needle brush
You MUST disconnect the power supply and
turn off the air purifier before cleaning.
Do NOT wash the collector in the dish-
washer.
Do NOT use cleaning products that contain
alcohol solutions, ammonia, or alkaline
substances, as these products may damage
the air purifier.
The collector should be cleaned approx.
once every two weeks or when needed. The
collector may require more frequent clean-
ing if used in highly contaminated environ-
ments.
Cleaning the collector:
1. Clean the collector with washing-up liquid,
water, and a soft sponge.
4

PRODUCT DESCRIPTION

CLEANING AND MAINTENANCE

2. Dry the collector with a dish towel.
3. Put the collector back on the ion generator
according to the above instructions.
If you have followed the above instructions
but the collector is still not clean, try the
following:
1. Spray detergent onto the collector and let
it work for 5 minutes.
2. Use a damp sponge and rub any
remaining spots until they disappear.
3. Dry the collector with a dish towel and
place it back on the ion generator
according to the above instructions.
4. Repeat the above procedure if necessary.