IKRA IMH 2500 Traduction Du Mode D'emploi D'origine page 16

EN
ENGLISH
WARNING
Risk of injury
Rotating blades may lead to serious injuries by cutting
or amputating parts of the body.
• Be careful to avoid injury by the cutting tools. Careful
appliance handling reduces the risk of injury by knife.
• Do not touch any dangerous moving parts before
the machine has been disconnected from the power
supply and the moving parts have come to a complete
standstill.
Before any adjustment, cleaning and maintenance work,
switch off the device and disconnect it from the power supply.
Wait until all rotating parts have stopped and the appliance
has cooled down.
Despite the observance of the operating instructions
there still may be some hidden residual risks.
Only use the device in the recommended position and
only on a firm flat surface.
Do not operate the device on paved or gravel surfaces
where ejected material may cause injury.
Check all screw and plug-in connections and protective
equipment if firm and tightened properly and whether all
moving parts are running smooth whenever the appliance
is to be put into operation.
Check that the shredder, shredder screws and other faste-
nings are securely fastened.
Replace worn or damaged blades and bolts in sets to
preserve balance;
Only replace cutting unit in pairs.
Damaged or illegible security stickers must be replaced..
Do not use the appliance in bad weather, especially when
there is a risk of storm.
Before starting the machine, make sure that the feeder is
empty.
Keep your face and body away from the feeding chute.
Hands, other parts of the body or clothing must not
be placed in the feeder, in the ejection channel or near
moving parts.
Do not use the appliance if you are tired, ill, under influ-
ence of drugs, alcohol drinks or medicaments.
Provide adequate lighting or good lighting conditions
when working with the machine. Poor lighting/light
conditions represent a high safety risk.
Do not overreach. Keep proper footing and balance at all
14
times. Provide a safe posture, especially on slopes.
When feeding material, never stand on a level higher than
the level of the base of the device.
Keep a distance from the ejection opening at all times.
When feeding material into the device, be extremely
careful not to insert metal pieces, stones, bottles, cans, or
other foreign objects.
Switch off the device immediately and wait until all
moving parts have come to a standstill in the event of a
foreign object being struck or if the device begins to make
unusual noises or vibrate.Disconnect the machine from
the power source and take the following steps before
restarting and operating the machine::
• check for damage;
• replace or repair damaged parts;
• check for loose parts and tighten them.
Do not allow processed material to accumulate in the ejec-
tion area as this may prevent proper ejection and cause
the material to bounce back through the feed opening.
The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
Never remove the collection bag when the machine is
being operated.
Never touch under the housing body when the engine is
running.
The protective equipment on the appliance is strictly
prohibited to be disassembled, changed, used in conflict
with the designation and it is prohibited to attach any
protective equipment of other manufacturers.
Keep the power source free of debris and other build-ups
to prevent damaging it or a possible fire.
Stop the device and disconnect it from the power supply.
Wait until all rotating parts have stopped and the appli-
ance has cooled down.
• whenever you leave the lawnmower
• before removing blockages
• before checking, cleaning or working on the device
• after contact with a foreign object, to check the device
for damage
• before freeing the device from accumulated material
• before tilting or transporting the device
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.