Selecting The Preset Band; Channel Preset Memory; Preset Tuning; Channel Scan - Kenwood KCA-CM50 Mode D'emploi

Selecting the Preset Band

Press the [u] button.
Each time the button is pressed the preset band switches
between the SR1,SR2,SR3, and SR4.

Channel Preset Memory

Putting the channel in the memory.
1
Select the preset band
Press the [u] button.
2
Select the channel to put in the memory
Press the [4] or [¢] button.
3
Put the channel in the memory
Press the [#1] — [#6] button for at least 2 seconds.
The preset number display blinks.
On each band, 1 channel can be put in the memory on each [#1]
— [#6] button.
Only the channel number is stored. Category information is not
stored.

Preset Tuning

Calling up the channels in the memory.
1
Select the preset band
Press the [u] button.
2
Call up the channel
Press the [#1] — [#6] button.

Channel Scan

Scanning for the channel you want to listen to.
1
Start Channel Scan
Press the [SEEK] button for at least 1 second.
"SCAN" indicator is ON.
2
Release it when the channel you want to listen to is received
Press the [SEEK] button for at least 1 second.

Channel Search

A channel is searched within the selected category.
1
Enter Channel Search mode
Press the [SRCH] button.
2
Select the Category
Press the [u] or [d] button.
3
Select the Channel
Press the [4] or [¢] button.
Canceling Channel Search
Press the [SRCH] button.
You cannot operate this unit until all the Category information is
acquired.
— 5 —