How To Install Water Line - Daewoo FRS-X22 Série Notice D'emploi

How to install Water Line

(Dispenser modes only)
1. The water pressure should be 2.0~12.5 kgf/cm² (1.96
~12.26 Bar) or more to run the automatic icemaker.
✽
Check your tap water pressure; if a cup of 180cc is
full within 10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not
close to any hot surfaces.
3. The water filter only filters water; it does not eliminate
any bacteria or microbes.
4. If the water pressure is not sufficient to run the
icemaker, call the local plumber to get an additional
water pressure pump.
5. The filter life depends on the amount of use. We
recommend you to replace the filter at least once
every 6 months.
✽
When attaching the filter, place it for easy access
(removing & replacing)
6. After installation of refrigerator and water line system,
select [WATER] on your control panel and press it for
2~3 minutes to supply water into the water tank and
dispense water.
7. Use plumbers thread sealing tape on every
connection of pipes/tubes to ensure there is no water
leaks.
8. The water tube should be connected to the cold water
line.
■ WATER SUPPLY KIT
✽
Check the parts below for installing water supply.
Some other necessary parts are available at your
local service agents.
Connector Filter box Water tube
Installation Procedure
models only)
1. Join Connector to the tap water line
Figure A
Connector A
Water tube
Figure B
Water tube
Place the rubber packing inside the tap connector
and screw onto the water tap.
2. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube. (Be
careful to follow the direction of the nut.)
3) Insert the Water Tube into the top of the water valve,
turn the nut clockwise to fasten it. (The water valve is
to the right of the motors.)
4) Check for any bent tubes or water leaks; if so,
recheck installation procedure.
5) Replace the rear cover. (The water tube should be
placed between the groove of the refrigerator back
and motor cover.)
Water tube
Set the tube upright as the figure shows.
(Dispenser
Tap
Connector B
Rubber packing
Tap
Connector A
Rubber packing
Water tube
Nut
Water valve
17