König Electronic HAV-AC10 Mode D'emploi page 3

Operation
Plug the cord into any 230 V AC home outlet. The entire display will flash, meaning the incorrect time is being
displayed. This is a normal condition and will stop when you set the time.
Setting the time
To set the time, press the TIME SET button (8), then press the HOUR SET button (5) and MINUTE SET button (6)
simultaneously. Release the buttons to confirm that the time is set.
Setting the alarm
To set the alarm, press the ALARM SET button (7), then press the HOUR SET button (5) and MINUTE SET button (6)
simultaneously. Release the buttons to confirm that the alarm is set.
To operate the alarm
Slide the ALARM ON/OFF button (3) to the "ON" position. The ALARM INDICATOR (1) will light up and the alarm will
sound at the preset alarm time. To swith the alarm off, slide the ALARM ON/OFF button (3) to the "OFF" position.
Snooze
When the alarm sounds, simply touch the SNOOZE BAR (4) to temporarily stop the alarm. The alarm will sound again
9 minutes later. This can be repeated as often you wish, for up to two hours.
Battery back-up (Battery not included)
In the event of a power failure, this unit will automatically switch to a battery standby circuit when a battery is installed.
Open the BATTERY COMPARTMENT at the bottom of the unit and install a 9 volt battery. Under battery operation, the
clock will keep the time running and the alarm will sound at the preset time. Only the clock display will not light up to
save battery power. If you have a long power failure you may need to make a slight adjustment to the clock time after
AC power returns. The clock uses an internal battery powered clock circuit that is less accurate than the power line
frequency. The alarm time will remain correct.
Specifications
Power source: 230 V ~ 50 Hz
DC battery: 9 V (1 x 9 V 6F22 / 6LR61 not included)
Power consumption: 2 W
3