OK INDUSTRIAL PTX Série Mode D'emploi page 4

O O p p e e r r a a t t i i o o n n
A A ) ) P P r r e e p p a a r r i i n n g g T T h h e e W
The PTX Series power tools require no assembly and are ready for use out of the
box. The battery powered version (model # PTX) requires an initial charge of the
battery of at least 8 hours. The LED will illuminate to indicate that the battery is
present in the charger. The LED remains lit as long as the battery is present, even
after full charging, but there is no danger in leaving the battery in the charger
Charger
(shown with Battery)
When the battery is not mounted in the tool or charger, it is important to ensure
that the terminals are not shorted by any metal or other conductive object. The
battery could otherwise short circuit, potentially causing fire, burns or battery
damage. The PTX-B is an environmentally friendly NiMH battery which can be
disposed of along with normal refuse.
CAUTION!
Do not attempt to use any other manufacturer's battery with the PTX, as it will not
perform properly and can damage the tool. Always use model # PTX-B batteries,
employing the model # PTX-BC1, PTX-BC2 or PTX-BC2-UK battery charger, both
manufactured by OK Industries.
Do not use the battery charger with a damaged cord or plug, or in wet or damp or
any outdoor environments, or in the vicinity of sinks or basins or other water
sources. Do not disassemble charger, there are no consumer serviceable parts
inside.
W r r a a p p / / U U n n w w r r a a p p T T o o o o l l
for longer than eight hours. Simply plug the charger (115V
model # PTX-BC1 or 230V model # PTX-BC2 or PTX-BC2-UK)
into a power outlet and place the
battery (model # PTX-B) in the charger.
After approximately 500-750 uses,
the battery should be disposed of
and replaced.
T T e e r r m m i i n n a a l l s s
o o f f B B a a t t t t e e r r y y
4