Safety Instructions; Brief Description; Scope Of Supply - Camille Bauer KINAX WT 717 Mode D'emploi

Operating Instructions
Transmitter for angular rotation, KINAX WT 717
Contents

1. Safety instructions .................................................... 13

1.1 Symbols .............................................................. 13
1.2 Proper use ........................................................... 13
1.3 Qualifications of the personnel ........................... 13
1.4 Repairs and modifications .................................. 13
2. Brief description ........................................................ 13
3. Scope of supply ........................................................ 13
4. Specification and ordering information ..................... 14
5. Technical data ........................................................... 14
6. Mounting ................................................................... 15
7. Adjusting the angle ................................................... 15
8. Electrical connections ............................................... 16
8.1 Connecting transmitter ....................................... 16
9. Fine adjustment ......................................................... 16
10. Simulation mode ....................................................... 17
11. Spare parts ................................................................ 17
12. Accessories ............................................................... 17
13. Maintenance .............................................................. 17
14. Dimensional drawings ............................................... 18
15. Declaration of conformity .......................................... 20
1. Safety instructions
1.1 Symbols
The symbols used in this operating instruction indicate
dangers and they have the following meanings:
Non-compliance could result in functional
failures.
Non-compliance could result in function
failures and injury to personnel.
1.2 Proper use
● The device is a transmitter with power supply for angular
rotation.
● The device is intended for mounting in industrial
installations and fulfils the requirements according to
EN 61010-1.
● The manufacturer is not liable for damage that is caused
by improper handling, modifications, or improper use.
● Optional with intrinsically safe output.
This is a "intrinsic safety apparatus» and can be installed
in explosion hazardous area. The output is intrinsically
safe.
1.3 Qualifications of the personnel
Mounting, installation, and commissioning must only be car-
ried out by properly trained and authorized personnel, who
have read and understood these operating instructions.
1.4 Repairs and modifications
Repairs and modifications must only be carried out at our
factory. The instrument must only be opened to make the
electrical connections and for programming, as described
in section "8.1 Connecting transmitter". The guarantee is no
longer valid if the instrument is further tampered with.
We reserve the right to make changes to improve the pro-
duct.

2. Brief description

The KINAX WT 717 converts the angular position of a shaft
into a load-independent direct current signal, proportional
to the angular position. The measuring range, sense of ro-
tation, characteristic, switching point and other additional
functions are programmed with the aid of a PC and the
software 2W2.
Explosion-proof "Intrinsically safe EEx ia IIC T6" ver-
sions with I.S. measuring output rounds off this series of
transmitters.

3. Scope of supply

Transmitter, one of the six versions (Fig. 1)
1 Operating Instructions (Fig. 2), in three languages:
German, French, English
1 Type examination certificate (Fig. 2), only for Ex version
devices
1 Blank label (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
13