Global Industrial 246608 Manuel De L'utilisateur page 3

b. Mount the INSTALLATION PLATE to the wall:
• Adjust the unit position to your requirements.
• Depending on type of installation fasten the INSTALLATION PLATE to the wall using the washers, spring
washers, and nuts. See the details below.
• Ensure the INSTALLATION PLATE is secure.
Installation on Steel Framework
c. Install the BODY by hanging it onto the INSTALLATION PLATE. Verify it is properly secured and tighten the
fixing screws. See the following diagram:
7) Use more than one Air Curtain unit with the appropriate length to support the width of a doorway.
8) The recommended distance between 2 adjacent units is 1-2 inches.
5. OPERATION INSTRUCTIONS
1) Plug the unit into an AC power outlet. (The OFF position is displayed with a lit lamp)
2) Select the LO or HI functions on the unit or Remote Control to regulate fan speed.
3) Adjust the AIR DEFLECTORS to direct air flow. See the following diagram:
6. WARNINGS AND MAINTENANCE
1) Be sure to install the unit in a stable environment for safety. Verify installation quality.
2) Do NOT install the Air Curtain within close proximity of water, high temperatures, or explosive / corrosive gases.
3) In case of malfunction or damage, a qualified technician should be contacted.
4) Ensure proper and consistent Air Curtain maintenance. (Do NOT clean the unit with benzene or other corrosive liquids)
WARNING
Unplug the power cord prior to any routine maintenance or servicing.
Air Curtain
Installation on Wooden Framework
1
2
3
Installation on Cement Wall
4
3
Instruction Manual