Technical Data - Outwell FUJI 560730 Mode D'emploi

UK: INSTRUCTION MANUAL
• This heater gets hot during use.
To avoid burns do not touch any surfaces
without protection gloves.
• Do not place towels or other objects on the heater.
• The heater must be installed at least 1.8 m above the floor/ground and
minimum 60cm distance to the ceiling surface.
• CAUTION - Some parts of heater can become very hot and cause burns.
Particular attention has to be given where children and vulnerable
people are present.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the heater provided that it has
been placed or installed in its intended normal operating position and they have been given supervision
or instruction concerning use of the heater in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the heater or
perform user maintenance.
• Avoid that the power cord (4) is hanging and exposed for contact with the heater cover (5), moving parts,
objects, or persons ensuring no danger of tipping the heater during use.
• Make sure to unplug the heater and await the heater to be completely cooled down before moving
or cleaning.
• Make sure to inspect and clean the heater for insects, bugs, cobweb and etc. before each use.
Use of the appliance:
• Place the heater on a firm, level ceiling surface.
• Distance to the ceiling surface by use: minimum 60cm
• Distance to ground/floor by use: minimum 180cm
• The hanging point / hook of which the heater will be hung up on must be able to support a weight of
minimum 5.6 kg.
• Place the hook A (8) to hook C (10) to ensure correct distance to ceiling surface (60cm).
• Place hook B (9) to the hanging point, hook of where you will hang up the heater.
• Plug the end of the cord (4) of the heater into power outlet.
• The Fuji Camping/Patio Heater is equipped with two heat settings: Low and High.
• To operate the heater on low (600W), pull the switch cord (3) once.
Once the switch cord (3) is pulled, the biggest top heating element (2) will glow and radiate heat.
• To operate the heater on high (1500W), pull the switch cord (3) again.
This will cause both (the bottom and top) heating elements (2) to glow and radiate heat.
• To disconnect the heater:
If both heating elements (2) are switched on: Pull the switch cord (3) one time.
If one heating element (2) is switched on: Pull the switch cord (3) two times.
• Remove the plug from outlet after the heater is switched off and cooled down.
Maintenance & storage instructions
• To keep the heater clean the outer shell (5) may be cleaned with a soft damp cloth. You may use a mild
detergent if necessary. After cleaning dry the unit with a soft cloth.
• Wait until the unit is completely dry before use.
• Do not use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the heater.
This may cause damage or deterioration to the surface of the heater.
• If the heater will not be used for a long period of time, store it in a cool, dry location.
To prevent the heater getting dusty, dirty or rusty keep and use the original packaging
for protection and storing.

Technical data:

220-240V 50-60Hz, 1500W
Protective Earth
Dispose of appliance as
electronic waste according
to local regulation
3