Time Setting - Eurotops M 3002 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

time and the designated LED will flash until the time adjustment is complete, then
the LED will turn off after 3 seconds and returns to normal running condition.

TIME SETTING

Before setting the hour and minute of local time, please check and if necessary, set
the correct local time zone first :
4.
PRESS and HOLD the button for approximatively 3 seconds until the LED
representing the local time zone flashes.
5.
When the LED is flashing, PRESS and HOLD again the button for about 3
seconds, until the LED representing the selected time zone moves from
flashing to stay on position. That means you just entered to the time setting
mode
6.
From the moment the LED stays on, two setting modes are possible :
3.1. Minute by minute mode when the LED stays on : a brief pressure on
the unique setting button will advance the minute hand of one minute.
3.2. Fast mode when the LED stays on : press and hold again the button
for about 3 seconds until the time streams quickly. You can then release
the button. For stopping the fast mode, a brief pressure on the unique
setting button is enough. Achieve your precise setting using the minute
by minute mode. (see 3.1)
Once the hour and minute is set correctly, wait for about 8 seconds for the
watch to exit the setting mode. If in any time the button is not pressed for 8
seconds, the watch will return to normal running condition automatically.
Repeat from step 1. If a new time setting is needed.
REPLACE OF BATTERY
 Replace the batteries if the watch stops running or the LEDs become dim.
 Replacement of battery should only be done by professional service personnel to
ensure the time accuracy and reliability of the water resistance of the watch.
 Replace battery type CR 2025 or equivalent.
The European directive 2012/19/EC about electronic and electric waste, requires that you can't
throw away defective domestic appliance with common waste. Used device has to be collect separately to
optimize the recuperation rate and the recycling of the materials to reduce the impact on the health and the
environment.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
M 3002 / W0302

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

W0302

Table des Matières