Uberhaus FZ-18D Guide De L'utilisateur page 5

4. SECURING THE TOWER FAN TO
THE PEDESTAL ASSEMBLY
 Carefully turn the fan on its side and place on
a table. Back of fan body is upward. Place the
power cord through the center of the pedestal
and base assembly (Fig.4).
Align the arrow on the wider end of rear pedestal
with the grove and arrow on the rear of the tower
fan unit and push Pedestal Assembly close to the
tower fan unit tightly (Fig. 4 ). Make sure to insert
the Locating Pillar at the bottom of the tower fan
unit into the Special Locating Slot of the Pedestal
Assembly properly.
when the buckles are properly connected
. SECURING THE POWER CORD TO THE
5
BASE ASSEMBLY
With the fan still on its side, locate the cord
holding bracket on the bottom of the base
assembly. Gently pull any slack out of the
power cord. Place the power cord securely
in the holding bracket and secure the power
cord bracket over the power cord. Then
thread the power cord through the "U" notch
at the edge of the base assembly (Fig. 6).
Return the tower fan to its upright position.
OPERATING INSTRUCTIONS
Once fan is fully assembled (see Assembly Instructions section), place fan on a level and dry surface. Plug
the power cord into a polarized 120 volt AC wall outlet.
USING THE CONTROL PANEL AND REMOTE CONTROL
This fan is equipped with 3 speeds, 3 breeze modes, a timer and remote. For your convenience, the buttons
on the control panel of the fan operates the same functions as the remote control.
POWER ON/OFF
To turn fan on, press the Power Button (
Press the Power Button again to turn the fan off.
The small screen above the Fan Speed Button indicates the room temperature.
SPEED CONTROL
To adjust the speed up or down, press the Fan Speed Button (
Adjust the fan speed to your desired level. 3 speeds:1=Low, 2=Medium, 3=High.
The selected speed will be displayed on the big LED screen above the front housing.
This button can be used with any mode, but when you press the timer setting button, the speed display will
not be visible. The different speeds can be recognized, though, through the different display length of the
grids: 3 grids = speed 1; 6 grids = speed 2; 9 grids = speed 3. Once finished with setting the timer, the speed
will display again after 10 seconds.
WIND MODE
Pressing Wind Mode Button (
There are 3 different wind mode options.
There should be a "click" sound
(Fig. 5).
) located in the center of the top control panel.
) will cycle the fan through different patterns of breeze modes.
).
5
Fig. 4
Fig. 5
Fig. 6