Hoover 48019772/01 Manuel D'utilisation page 7

Chapter 1.3 - Switching on the Appliance
Connect the appliance with the mains cord to the earthed socket. Press on the main switch (12), the power
light (11) will illuminate red color, turn the temperature dial (8) to your desired setting, the iron heating light
(10) will illuminate informing you that the appliance is heating up, this will turn off when the soleplate reaches
the selected temperature.
After approximately 1 minute, the iron heating light (10) will go off, then you can start ironing.
N.B.
The first time the appliance is used, some fumes, dust and a smell should appear.
It's quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 2.4 Vertical Steam Ironing.
Chapter 2: Using Your Steam Generator
Chapter 2.1: Regulating the Soleplate Temperature
Select the temperature of the soleplate by turning the dial (8) on the iron to the desired position.
Wait a few moments until the iron heating light (10) is off.
It will indicate to you that the soleplate has reached the requested temperature.
While ironing, the iron heating light (10) may turn on and off, the temperature adjusts
without interrupting your ironing.
Help
To know the best suitable temperature for each textile, check the laundry care label of the
article to be ironed. Please note that during use, the temperature light goes on from time
to time. It signifies that the iron is heating up to the set temperature.
If a fabric is made with various kinds of fibers always select the soleplate temperature
adequacy with the most delicate one.
If you select a lower temperature while ironing, wait until the iron has cooled down to the set temperature before
you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the
temperature above the 2 dots (••) to avoid this issue.
Chapter 2.2 - Ironing
Dry Ironing
Select the temperature of the soleplate following the indications of chapter
3.1. Start your ironing without pressing the steam trigger (7), when the
soleplate reaches the appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indications of chapter
3.1. The steam will be ready to be used after 1 minute and the dedicated
lamp will turn off. Starting from that time you can begin your
ironing and press the steam trigger (7) for having steam.
N.B.
During the use, you should hear some noise coming from your steam generator. It's totally normal. It signifies
that a pump injects water into iron soleplate.
5 GB
Fig. 6: Pressing Steam Trigger Graphic
in