Glacier bay QK001 Manuel De L'utilisateur page 8

Installation
INSTALLING THE SINK
NOTE:
Install the vanishing edge TM strainer according to the instructions before completing this step. See page 11.
- Press fit the threaded anchor inserts (E) into the holes drilled into the underside of the countertop. Use a bolt to make this process easier if
required .
- Loosely thread the undermount bolts and clips into the threaded anchor inserts and align them parallel to the sink flange outline so they do
not interfere with the placement of the sink .
- Place a small bead of silicone sealant (not included) around the outer top perimeter of the sink flange as shown below.
- Carefully place the sink (A) into its location under the counter, lining up the pencil marks on the top of the sink that you made when you
tested the fit of the sink.
- Carefully rotate the clamps of the undermount clips (E) over the clamp bar on the sink (A) and gently tighten the bolts (see tightening
sequence) of the undermount clips (E), working from side to side to fasten the sink (A) firmly. Recheck the alignment visually from above.
- Wipe away any excess silicone and, for best results, allow the bond to rest undisturbed for 8 hours or overnight .
- Install the counter, faucet, and all other plumbing as per manufacturer's instructions .
E
SUPPLY LINES (NOT INCLUDED)
The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately .
Follow the supply line manufacturer's instructions for proper installation .
A
Silicone
Sealant
Tightening sequence for clips
8
6 2 4
9 7
10 8
3 5 1