Télécharger Imprimer la page

navod 160 85 TLC Prescriptions De Montage Et Mode D'emploi page 23

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
OPERATION
GB
Maintenance
Prior to any maintenance operation ensure that the cooker hood is disconnected from the
electrical outlet.
Cleaning
The hood must be cleaned frequently both inside (apart from the area behind the grease filter)
and outside. Use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use
products containing abrasives.
Warning
Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the
filters may cause fire risks. Therefore we recommend observing these instructions.
Anti-grease Filter
must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low
temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly,
but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version)
Carbon filters can be regenerated only once by washing at low temperature in a dishwasher, then
drying in an ordinary kitchen oven at 90ºC for approx. 10 minutes. Each filter must be regenerated
or replaced as soon as the respective warning indicator on the hood lights up. For hoods without
filter replacement warning indicators, we recommend washing / replacement approximately every
six months assuming the hood and cooker are in normal use.
Reducing environmental impact:
To reduce energy consumption, we recommend you always use the lowest suction speed among
those suitable for the cooking mode currently active, avoid leaving the appliance running for more
than 15 minutes after burner shutdown and switch off the lights if you leave the cooking area.
Replacing lightbulbs
Warning! Prior to touching the light bulbs ensure they are cooled down.
Led Light
If the lighting group LED does not work, please contact the technical service center in order to
replace the whole group.
Open the light cover by pressing with a finger the part marked push".
Replace the dead bulb.
Use only a halogen bulb of 20W max (G4), taking care not to touch it with naked hands.
Close the light cover.
23

Publicité

loading

Ce manuel est également adapté pour:

160 120 tlc