Linea Domo DO7341H Mode D'emploi page 37

www.domo-elektro.be
• The appliance will also atuomatically measure if it has to heat or not. If the room
temperature is higher than the set temperature, then the appliance will go into
standby mode after 10 seconds and stop heating, until the appliance notices that
the room temperature has dropped 2°C below its set temperature. If that is the
case, the appliance will start heating again until the set temperature is reached.
• You can also set a timer. Press the timer button and set the time using the + and
- buttons. you can choose between an operation time of 1 upto 12 hours. Press
the timer button again to confirm the operation time. As soon as the set time has
passed, the appliance will stop heating and go into standby mode.
HOW TO USE THE REMOTE
• At the bottom of the remote control you can find the battery compartment. Open
the compartment by pushing the small left button to the center and simultaneously
sliding out the compartment. You can now place a new CR2032 3V battery. Make
sure that the battery is placed correctly, also what the polarity is concerned.
• The remote buttons have the same functionality as the buttons on the appliance.
So you can also set the power, temperature and time with the remote.
HOW TO MAINTAIN THE APPLIANCE
• At the back of the appliance, you can find the air filter (part 8). This filter catches
dust when the appliance is in use, so it should be regularly cleaned to make sure
that the heating capacity of the appliance remains the same.
• The filter can be cleaned with water, but make sure that you completely air dry the
filter before placing it back into the appliance.
• When cleaning the outside of the appliance, do not use any oils or other abrasive
products that could damage the appliance.
• When storing the appliance, make sure that it has completely cooled down, that
you pack the appliance well and that you store it in a well vented environment.
37
DO7341H