Unpacking The Device; Location Of Controls; Charging The Device - LEXIBOOK Star Wars Bluetooth Mode D'emploi

UNPACKING THE DEVICE

When unpacking, ensure that the following elements are included:
1 x Bluetooth® Stereo Headphone / 1 x micro USB cable /
1 x 3.5mm audio cable
WARNING: All packaging materials, such as tape, plastic sheets, wire ties
and tags are not part of this product and should be discarded.

LOCATION OF CONTROLS

1. Power on/off
2. Play/Pause
Pairing
Call button
3. Volume + / Next track
4. Volume - / Previous track
TURNING THE DEVICE ON AND OFF
1. To turn the headphone on, press and hold the Power button (1) for 2
seconds.
2. To turn it off, press and hold the Power button for 2 seconds.
3. This Bluetooth® headphone offers auto on/off function. So once you put the
headphone on your ears, it will automatically turn on, and automatically turn
off if you don't wear it for more than 5 minutes.
Notes:
- If the button (5) is switched on, Darth Vader eyes will be lighting up while
pressing Power on/off.
-When the battery is too low, the headphone powers off automatically to
protect the product.
WARNING: Significant electromagnetic interference or electrostatic
discharges may cause the device to malfunction or lose data. If the device is
not functioning correctly, switch it off and then on again, or unplug the USB
cable.

CHARGING THE DEVICE

1. Make sure to power off the headphone before charging it.
2. Connect the micro USB side of the cable to the headphone's micro USB
port (8).
3. Connect the other side of the cable to an USB power source.
Notes:
- The LED (7) lights up red when the headphone is charging.
- The LED (7) indicator turns off when charging is complete.
1. Activate the Bluetooth ® function on your personal device (smartphone,
MP3 player, etc.). Please refer to your device's instruction manual on how to
activate this function.
2. Turn the headphone on to activate the auto-detection of a nearby device.
Darth Vader eyes flash.
Notes:
- If your player and the headphone do not automatically pair with each other,
please select "BTHP500SW" in the Bluetooth ® list.
- When turned on, the headphone automatically searches for the device it has
previously synchronized with.
- If no device is detected, the headphone will start pairing a new device.
- Press the PAIRING button (1) for two seconds to disconnect the headphone
from the current device and start a new pairing.
- If your Bluetooth ® device requires a password, the default password is 0000.
- Darth Vader eyes flash twice every 3 seconds when the headphone is
paired.
5. Switch to turn on/off Darth
Vader eyes
6. Microphone
7. LED indicator
8. Micro USB port
9. 3.5mm jack for wired headphone
PAIRING
7