Use Precautions - air&me Pump it up Guide D'utilisation

COMPONENTS (SEE PAGE 2)
Water outlet
1
Water inlet
2
Suction cups
3
Drainage hose
4
Pump filter
5

USE PRECAUTIONS

• The PUMP IT UP water-pump is reserved for private and domestic use only; mostly for drai-
nage, disposal and water transfer. The pump is made to stay inside the tank of a domestic air
dehumidifier fitted with continuous drainage function.
• Only use the hose provided with your pump. Using another hose could damage the wa-
ter-pump or it could not be adapted.
• Do not try to extend the hose: the water-pump is designed for lifting the water to a maximum
of 3 meter.
• Do not leave the water pump in stagnant water while the appliance is switched off.
OPERATING INSTRUCTIONS
1. Connect the hose to the pump's water outlet. Make sure it is well connected. Then connect
the female connector of the electric cable with the male connector. This junction has to be
placed outside of the tank and outside of the dehumidifier.
2. Place the pump at the bottom of the air dehumidifier tank. It is perfectly hermetic and de-
signed to be immersed under water up to 50 cm deep.
3. Ensure that the drainage hose is running onto a water outlet installation (sink, drain, toilets
etc.) after going through the outlet of the appliance.
4. Plug the electric cable into a safe wall socket, after going through the outlet of the ap-
pliance. Your water pump is now ready to be used.
When the water level reaches the sensor, the pump automatically switches on and water is
drained away. When the water level is below the sensor, the pump automatically switches off.
PUMP IN OPERATING SITUATION (SEE PAGE 3)
Air dehumidifier fitted with continuous
1
drainage function
Tank
2
Pump
3
Male and female electrical junction
4
10
Water level sensor
6
Female connector
7
Male connector
8
AC adaptor
9
Electric supply
5
Hose and electric cable outlet
6
Drainage hose
7
To water outlet
8