Muting And Unmuting A Call; Call Waiting; Sending Dual Tone Multi Frequency Tones - Toyota SWC Mode D'emploi

Muting and unmuting a call

Using the user interface module
Action
To mute the microphone during a call, press and hold either volume up/down button.
To unmute the microphone, press and release either volume up/down button.
Using the mute and unmute commands
Action
To mute the microphone during a call, press and hold the mode button. When prompted, say
"Mute".
To unmute the microphone, press and hold the mode button. When prompted, say "Unmute".

Call waiting

When you are on a call, an audible beep signals a 2nd call.
Action
Press and release the arrow up button to place the 1st call on hold and answer the incoming call.
Each time you press and release the arrow up button, you toggle between active calls.
Note: If the arrow up button is not pressed, the incoming call is automatically rejected and sent to
voicemail (if set up on the phone).

Sending dual tone multi frequency tones

Note: Dual tone multi frequency = DTMF, also known as touch-tone.
You can send DTMF tones from the phone keypad, or by using the
Action
1 Press and hold the mode button.
2 When prompted, say "Enter
20 Using your Bluetooth
<digits>
®
hands-free system
" to send numbers as Dual tone multi frequency tones.
enter command: