Iagnostics; Table 9-16: Parameter Types; Table 9-17: Error Codes - Fluke Thermalert 4.0 Manuel Utilisateur

To send the parameters and their values to the device, they must be stored in the controller tags first and then
copied to their destination register in the device. Please note, that most of the values of the parameters are REALs
whereas the parameter for laser control uses UDINT format – at least this value must be stored in a separate tag.
9.5 Diagnostics
The EtherNet/IP device has a designated status register. The bits of this register make up for an error code, which
is sent as a part of input data.
0x05
It can be translated using the table below.
1.800.561.8187

Table 9-16: Parameter Types

Type of parameter Meaning
0 Do not change anything
1 Emissivity
2 Transmissivity
3 Averaging time
4 Peak hold time
5 Valley hold time
6 Laser control
Status

Table 9-17: Error Codes

Bit Description
2 Internal temperature over range
3 Internal temperature under range
9 Object temperature under range
10 Object temperature over range
17 EtherNet/IP not ready
www.
Format
REAL
REAL
REAL
REAL
REAL
UDINT
DWORD
information@itm.com
.com
EtherNet/IP
Diagnostics
4 Byte
67
9