Gewiss GW A9 471 Manuel D'utilisation page 16

GENERAL DESCRIPTION
SCENE MANAGEMENT
Used to activate a scene (short touch, ≤ 3 s) or memorise the new values (long touch, > 3 s). One
scene can be associated with each channel.
In this mode the localisation LED blinks briefly if a scene learning command is being sent. The
signalling can, however, be associated with the status of an actuator contact via the specific status
channel (to be explicitly selected during the function creation phase).
LIGHT SIGNALLING
Each channel of the push-button panel module has an RGB LED for back-lighting. The default set-
ting is: amber for night-time localisation and blue for load status signalling. This default setting can
be changed as follows.
Change mode input
1. touch the plate as shown in figure B for at least 15 seconds, without touching the device chan-
nels
2. wait until you hear two long beeps, then release
3. wait until all six LEDs are flashing magenta
4. activation of LED 1 red, LED 2 white, LED 3 and LED 5 according to the configuration active at
that moment
Parameter personalisation
1. touch
a) push-button CH1 to access the personalisation of the load status signalling colour
b) push-button CH2 to access the personalisation of the night-time localisation colour
2. wait until LED 1 or LED 2 (depending on which of the two channels is selected) briefly flashes
red (all the other LEDs are deactivated)
3. activation of all the LEDs according to the configuration active at that moment
4. cyclically change the colour of night-time localisation or status signalling by making consecu-
tive touches on the corresponding channel, as indicated in the table:
Customisation options
LED1....LED6
Flashing white
White
Yellow
Magenta
Red
Turquoise
Green
Blue
Amber
NIGHT-TIME LOCALISATION or
STATUS SIGNALLNG
Off
White
Yellow
Magenta
Red
Turquoise
Green
Blue
Amber
16
E
N
G
L
I
S
H