HOFFLIGHTS ZANZIBAR Manuel D'installation page 23

REMOTE
CONTROL
KDINDLY REMINDERS
1. Learning code matching mode is used between REMOTE CONTROLand receiver. Turn "ON" the supply power within
30 seconds and press the REMOTE CONTROL"FAN ON/OFF" button for 5 seconds, it can load normally after hearing a
long sound "bee", which means learning successfully and it can works normally.(PS: Learning mode is not accepted
after turn "ON" the supply power for 30 seconds)
2. When the emitter cannot control the receiver, please check the battery POLE touching normally or not, correction of
the positive and negative, full or empty of the power.
3. When the REMOTE CONTROLr cannot control the receiver, please check if there any existence of similar remote con-
trolled products nearby, then check whether they works, because remote controlled product with the same frequency
will disturb each other.
4. Low voltage of battery will affect the sensitivity of the REMOTE CONTROLand the signal reception accordingly(the
indicated light will flash out its warning when the battery get low voltage), must replace if the battery is getting low
voltage.
5. Please take out the battery from the REMOTE CONTROL when leaving unused for long time
6. Supporting 200W lighting power at maximum.
7. PS: please connect the ground wire correctly, otherwise it may cause the light micro-light or flash
8. When installing the fan, the fan ceiling cover don't press the antenna(or other wire), it is easy to breakdown the wire
and short-circuited.
hofflights.com
USER MANUAL
IMH-099 v.01
23