König Electronic KN-STUDIO90 Mode D'emploi page 4

Additional Instruction-Please read before use.
● WHEN ADJUSTING FLASH OUTPUT
When adjusting the output for each Flash, the user must first trigger the Flash to obtain the new
capacity, otherwise the flash will trigger at the last (previous) setting and this may blow the fuse
during the flash.
● SWITCHING OFF THE FLASH PROCEDURE
To switch off the flash:
● Switch off at each flash head.
● Fire off each flash head with the test button to drain any remaining current left in each unit
(capacitor).If this procedure is not done, it may cause the fuse to blow.
● DO NOT USE CONE DIFFUSER
The flash head is not suitable to be used with a cone diffuser as it may over heat. This will cause
damage to the head unit.
● DUTY CYCLE (Continuous use)
The flash can be used at full power for 5 minutes continuously. Then it should be cooled down for
a few minutes. Overheating will occur if used continuously without cooling down.
Declaration of conformity
We,
Nedis B.V., De Tweeling 28, 5215MC 's-Hertogenbosch, The Netherlands
Tel.: 0031 73 599 1055, Email: info@nedis.com
Declare that product:
Brand: König Electronic
Model: KN-STUDIO90
Description: Photo studio
Is in conformity with the following standards:
EN55015:2006
EN61000-3-2:2006
EN61000-3-3:1995+A1:2001+A2:2005
EN61547:1995+A1:2000
EN60065:2002+A1:2006
EN60598-1:2004
EN60598-2-9:1989+A1:1994
And complies with the requirements of the European Union Directives.2004/108/EC and 2006/95/EC
's-Hertogenbosch, 27-05-2009
Mrs. J. Gilad
Purchase director
4