Main Power Switch; Video Out; Audio Input; Video Input - König Electronic SEC-DVRMON20 Mode D'emploi

3. MAIN POWER SWITCH

Switch ON or OFF the DVR system.

4. VIDEO OUT

Video output signal for another monitor.
5. AUDIO INPUT (1 & 2)
Audio input for a microphone connection. Audio1 IN is audio for CH1 and also audible if switched to quad view. Audio2
IN is audio for CH2 and only audible if CH2 is selected and not if quad view is chosen.
6. PS2/MOUSE
Connection for mouse (included).
7. HDD POSITION
Position to install a HDD (remove the 4 screws of the grid to access).

8. VIDEO INPUT

Video input for CH1, 2, 3 and 4.
9. RS485 / ALARM / SENSOR
RS485 Power line ports. To control high-speed dome camera.
ALARM Input for alarm device.
SENSOR Input for 4 motion sensors (PIR) to start recording by motion detection.
Description Side Panel:
USB port for back-up and software update
Description Remote Control:
Safety precautions:
Do not expose the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
1. CH1↑ Select CH1 or move cursor up
2. CH2↓ Select CH2 or move cursor down
3. CH3← Select CH3 or reduce value
4. CH4→ Select or increase value
5. QUAD Quad view
6. ◄◄ (Z-) Rewind or zoom-
7. ► (F+) Play record list or focus+
8. ►► (Z+) Forward or zoom+ or channel auto sequence switch
9. ● Manual recording or stop manual recording or Level scan
10. ▌▌ (F-) Pause or focus-
11. ■ Stop playing or stop dome running
12. PTZ PTZ switch
13. Menu/ESC Enter or exit setup menu
14. Select/Enter Modify item or increase value
15. UP Move up cursor
16. DOWN Move down cursor
USB Port
4