Table des Matières
Publicité
Installation procedure
1
Remove the screws (2 locations) from the bottom of
the hung on wall unit with a Phillips head (+) screw
driver.
Screws M6
2
Remove the hardware on the wall side and the hard-
ware on the PDP side.
1 Push the pin on the bottom side and pull out the bottom side
of the PDP side hardware.
2 Lift up and remove the PDP side hardware.
Wall side
hardware
Pin
Push
1
3
Attach the PDP side hardware to the plasma display.
Warning
• Cover the display with a sheet or similar protective material
to protect it from scratches or other damage.
• Be sure to attach it on top of a flat table or similar surface.
PDP side hardware
Plasma display
6
En
Pin
2
PDP side
hardware
Top side of
plasma display
4
Fix the plasma display to the PDP side hardware with
bolt M8 (6 locations).
5
Attach the wall side hardware to the wall.
Fix the unit with screws (at 4 or more locations) sym-
metrically on the left and right side. Because the
screws and bolts used to do this are different accord-
ing to the wall strength and wall material, purchase
suitable screws and bolts separately.
Warning
Check the strength of the wall and beams before installing the
display.
6
Attach the hook on the PDP side hardware to the
wall side hardware.
While it is hooked, the pin on the bottom side does not go in, so
push the pin in.
Hook
Wall side
hardware
PDP side
hardware
Pin
Push
Top side of plasma display
Wall side
hardware
PDP side
hardware
Publicité
Table des Matières
