Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Max GearLoft™ Shelf Use
Requirements
Intended to be installed on Gladiator
■
GearTrack
channels.
®
Maximum weight limit is 200 lbs (91 kg).
■
Unpack the Max GearLoft™ Shelf
1. Remove and verify the contents. Contents include a hex key,
and the parts and fasteners shown in "Parts."
2. Dispose of all packaging materials properly.
IMPORTANT: Determine whether you will be mounting the shelf to the wall with the braces above or below the shelf.
1.
Mounting braces below shelf
A. Brace attached to the Shelf
With the braces pointing downward, align the braces with the
center and back holes on the each side of the shelf.
Use 5/16" Hex head bolts (F1) and 5/16" Flange nuts (F2) to
attach a brace to each side of the shelf. Fully tighten the bolts.
4
GearWall
panels or
®
®
Parts
ASSEMBLY INSTRUCTIONS
A
Tools and Parts
Gather the required tools and parts before starting assembly.
■
Read entire manual before starting assembly.
■
Tools Needed
1/2" Socket Wrench
■
1/2" Open end Wrench
■
Tools Supplied
5/16" Hex key
■
2.
Mounting braces above shelf
A. Brace attached to the Shelf
With the braces pointing upward, align the braces with the
center and back holes on the each side of the shelf.
Use 5/16" Hex head bolts (F1) and 5/16" Flange nuts (F2) to
attach a brace to each side of the shelf. Fully tighten the bolts.
A
Publicité
Table des Matières
