Handle Assembly; Adding Oil; 3/ Use - WIDMANN MD9000T Manuel D'utilisation

EN
MD9000T – CRIC SURBAISSE 2.5T
3/ Floor jack use
Read carefully safety instructions mentionned in this manual

HANDLE ASSEMBLY

1- Assemble the upper part with the lower part of the handle
2- Insert the handle into the corresponding space of the jack
3- Secure the handle to the jack using the screw
- PURGE
1. Unscrew the cylinder screw
2.Turn the jack handle counterclockwise as shown
3. Move the stick up and down quickly and several times to purge the air. 4. Tighten the
cylinder screw when the operations are finished.

- ADDING OIL

1. Remove the cylinder screw.
2. Fill with hydraulic oil
3. Do not operate the handle when filling.
4. Replace the cylinder screw when the operations are complete.
- LIFTING
1. Place the vehicle on a hard, level surface.
2. Turn the jack handle counterclockwise to lower it to the lowest level.
3. Turn the handle clockwise and place the jack under the jacking point of the vehicle.
4. Operate the jack handle up and down until it reaches the lifting point
of the vehicle.
5. Continue to operate the joystick to raise the vehicle.
6. Turn the jack handle slightly counterclockwise to lower the vehicle.
- DESCENT OF THE VEHICLE
1. Remove all tools and objects from under the vehicle.
2. Raise the jack so that the jack stands on which the vehicle rests can be released and
removed.
3. Turn the handle counterclockwise to lower the jack and vehicle to the ground.
4. Remove the jack and keep it in a dry place.
11