Installation And Assembly Instructions - Pioneer PDK-FS03 Mode D'emploi

Installation and assembly instructions

1
Attaching the support columns to the stand.
The attachment procedure varies according to the type
and form of the plasma display to be attached. Per-
form this attachment using either procedure A or B.
A
When installing speakers on both sides of the
plasma display
Insert the support columns into the stand and fix them in
place with screws (M5 x 10mm [13/32 inch]). (8 locations)
Install each support column so that the side with the symbol
is forward and the end with the plastic end cap (pointed) is
upwards.
End with end cap
points upwards.
Side with the
symbol is
forward.
Screw
(M5 x 10 mm
[13/32 inch])
B
When installing speakers at the bottom of the
plasma display
Attach the support column stoppers to the notches on the back
of the stand and fix them in place with screws (M5 x 10mm [13/
32 inch]). (2 locations on the right and left)
The same applies to support column attachment method A.
10
En
Support column
Support column
stopper
Screw
(M5 x 10 mm [13/32 inch])
(43-inch display model in the figure)
2
Attach plasma display to support column.
Fit the stand's support columns into the slots in the center of
the bottom of the plasma display then slowly insert them
directly into the slots. Be extremely careful not to insert the
support columns of the stand into any part of the plasma
display other than the stand insertion slots. Note that doing so
might damage the plasma display panel or its ports or result in
the warping of the stand.
If the plasma display is fitted with handles, it is usually best to
hold the display by its handles when attaching it to the
support column.
Be sure to work with at least one other person
when attaching the display.
Be careful not to allow your fingers get caught
Caution
between the display and support column.
3
Use the hexagonal bolts to fix the plasma display to
the support column (4 locations).
It you are attaching speakers, do so at this stage.
See the installation instructions provided with your
speakers for instructions on how to install them.
Line up the column supports
with the bottom of the plasma
display as indicated in the
accompanying diagram.
Hexagonal
bolts
(M8 x 35 mm
[1-3/8 inch])