Plumbing Connections - COPERTINA KOMPACT AMS Série Manuel D'installation

PLUMBING CONNECTIONS

2
4
6
6
4
8
11
4
6
6
4
13
After around 800 hours of work, tighten the bolts on the pump body, applying a tightening torque of
When making the plumbing connections, make sure that you follow the instructions below:
The BOTTOM FILTER must be installed so that it is always positioned 5-10 cm from the bottom, in order to prevent any
-
formation of deposits.
nstallation of a pump suction head is recommended for pumps with very low flow rates.
- I
products which develop gas (e.g. sodium hypochlorite, hydrazine, hydrogen peroxide, etc.).
If you need to use longer hoses than those provided in the installation kit, it is important that you use hoses of the same
-
dimensions as those supplied with the pump.
using a black hose able to withstand ultraviolet rays.
It is advisable to position the
-
The
- INJECTION VALVE
the dosing flow.
START-UP
Once all the aforementioned operations have been completed, the pump is ready to be started
Priming
- Start the pump.
- Open the priming connector by turning the knob in a counter-clockwise direction and wait for liquid to come out of the pipe
connected to it.
Once you are sure that the pump is completely full of liquid, you can close the connector and the pump will begin to dose.
-
EM00136185
1
3
5
7
5
9
10
14
5
12
5
3
Fixing templates wall bracket
If the
INJECTION POINT
, supplied with the pump, must always be installed at the end of the delivery line on of
rev.1.1
1. Injection point
2. Injection fitting
3. Seal
4. Pipe holder
5. Pipe clamp
6. Ring nut
7. Delivery hose (rigid)
8. Delivery valve
9. Pump body
10. Bleed valve
11. Suction valve
12. Suction hose (soft)
13. Bottom filter
14. Bleed valve connector
DELIVERY HOSE may be exposed to the sun's rays, we r
higher than the pump or tank.
EN
3 Nm.
In particular, when dosing
ecommend
.
3