Krüger & Matz KM0513 Mode D'emploi page 9

Owner's manual
1. Power cable
2. Fuse
3. Power switch
4. Standby switch
5. Phase knob
6. Crossover knob
7. Volume knob
8. Line output
9. Line input
10. Bass adjustment knob
TROUBLESHOOTING
If you're experiencing difficulties while using this product, read the table
below. Check if the problem was not caused by other equipment (please
check the connection). If you are unable to solve the problem, contact an
authorized service point for check up/repair.
Problem Possible reason
No sound 1. Power was turned off
2. Power plug has been unplugged
3. Volume set to minimum
No power 1. Power was turned off
SPECIFICATION
Power output (RMS)
Frequency response
Phase selection
S/N ratio
Power consumption in standby
Impedance
Bass extension
Crossover
Speaker size
Power supply
Solution
1. Turn the power on
2. Connect power cord (make
sure it's properly plugged)
3. Adjust the volume level
1. Turn the power on
KM0513
120 W
50 Hz ~ 150 Hz
0º ~ 180º
>= 80 dB
0,5 W
4 Ohm
----
50~150 Hz
10"
AC 220-240 V / 50 Hz
KM0514
200 W
40 Hz ~ 200 Hz
0º ~ 180º
>= 80 dB
0,5 W
4 Ohm
0~6 dB
40~200 Hz
12"
AC 220-240 V / 50 Hz
9