Safety Instructions; Maintenance Instructions - GYS PRESS 8T Mode D'emploi

Translation of
the original
notice
DESCRIPTION
The blind rivet adapter is compatible with the GYSPRESS 8T/10T and GYSPRESS 8T/10T PUSH PULL riveters. ]Its tensile force is 50
kN. It allows the setting of blind rivets with diameters from 4.0 to 7.8 mm for aluminium and 4.0 to 6.4 mm for steel.

SAFETY INSTRUCTIONS

• The 50KN adapter must not be used for anything other than setting blind rivets and blind rivet nuts and bolts.
• Mandatory wearing: safety glasses, anti-noise protection, safety gloves. Never point the nose of the tool towards
yourself or anyone else.
• Never exceed the maximum allowable pressure of 7 bar.
• Blind rivets must be used according to the specifications..
• Fit the end cap according to the size of the rivet. Never force the rivet tail into the nozzle. Never use a nozzle
wider than the rivet tail.
• Check that the clamping of the part to be riveted is correct.
• Hold the riveter firmly until the rivet tail cut is completed and ejected. Otherwise, release the trigger and then
resume pulling by pressing the trigger again,
• Always unplug the machine after each use and after changing the riveting head.
• Keep this user manual in a safe place. In case of loss, please contact us.
ENVIRONMENT
This equipment must only be used for riveting operations in accordance with the limits indicated on the descriptive panel and/or in
the user manual. Safety instructions must be followed. In case of improper or unsafe use, the manufacturer cannot be held liable.
This equipment must be used and stored in a room free from dust, acid, flammable gas or any other corrosive agent. Operate the
machine in an open, or well-ventilated area.
Operating temperature:
Use between -10 and +40°C (+14 and +104°F).
Storage between -20 and +55°C (-4 and 131°F).
Air humidity:
Lower or equal to 50% at 40°C (104°F).
Lower or equal to 90% at 20°C (68°F).
Altitude:
Up to 1000 meters above sea level (3280 feet).
IN CASE OF A BREAKDOWN
The riveting operation is not performed:
• Check that the stroke adjusting nut is set to the correct value.
• Check that the riveter being used is working properly.
• Check for oil or compressed air leaks.

MAINTENANCE INSTRUCTIONS

• Keep the tool in a good state of cleanliness. Periodically check that the compressed air connections are in good
condition and that the 50 kN adapter (the natural play between the rivet shank and the bit) is working properly.
• In case of oil leakage, remove from the riveting machine and turn the tool over.
• Replacing the jaws (see p.6)
SUMMARY
Riveting Machines
GYSPRESS 8T
GYSPRESS 8T PP
GYSPRESS 10T
GYSPRESS 10T PP
GYSPRESS 10T Connect
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
Power
40 kN
40 kN
50 kN
50 kN
50 kN
EN