Safety Instructions; Important - SX Lighting EASYLIGHT Notice D'utilisation

ENGLISH – ENGLISH - ENGLISH – ENGLISH - ENGLISH – ENGLISH – ENGLISH

SAFETY INSTRUCTIONS

Please read carefully the instruction, which includes important information
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure
that they also receive this instruction manual.

Important:

Damages caused by the disregard of this user manual are not subject to warranty. The
dealer will not accept liability for any resulting defects or problems.
Unpack and check carefully that there is no transportation damage before using the unit.

The unit is for indoor use only. Use only in a dry location.

DO install and operate by qualified operator.

DO NOT allow children to operate the fixture.

Use safety chain when fixing the unit. Handle the unit by carrying its base instead of

head only.
The unit must be installed in a location with adequate ventilation, at least 50cm from

adjacent surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.

Before operating, ensure that the voltage and frequency of power supply match the

power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric

shock.
Maximum ambient temperature Ta: 40℃. DO NOT operate it when the temperature is

higher.
DO NOT connect the device to any dimmer pack.

During initial start-up some smoke or smell may arise. This is a normal process and does

not necessarily mean that the device is defective, and it will decrease gradually within 15
minutes.
Make sure there are no flammable materials close to the unit while operating to avoid fire

hazard.
Examine the power wires carefully, replace them immediately if there is any damage.

Unit's surface temperature may reach up to 85℃. DO NOT touch the housing bare-

handed during its operation, and allow about 15 minutes for cooling the unit down before
replacing bulb or maintenance as it could be very hot.
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens,

cut off the mains power immediately.
DO NOT operate in dirty or dusty environment, do clean fixtures regularly.

about the installation, usage and maintenance.