Troubleshooting Guide - Atlantic Colorfalls CC06 Manuel D'utilisation

• The Colorfalls has been disassembled or modified other than as described in
this manual.
• The Control Module and/or Remote Control have not been adequately
protected from moisture.
• This warranty excludes labor/costs of labor for removal or installation of any product.

Troubleshooting Guide

Always turn off power before inspecting the Colorfalls. Failure to observe this
precaution can result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the
problem persists, contact your dealer.
Problem
Remote is not working
(no indicator light)
Remote is not working
(indicator light is on)
Light bar will
not illuminate
Light color is not
synced with remote
Water leaking from
Colorfalls body
Diminished water flow
Waterfall sheer is
splitting
Possible Cause
No batteries / batteries
installed incorrectly
Remote is not synced with
Control Module
No power to outlet
No power to Control
Module
No Power to Light Bar
The arrows on the plugs are
not aligned.
Bad plumbing connection
Gasket out of place
Screws in back plate are too
loose
Blocked pump intake
Obstruction in plumbing
line
Debris in Colorfalls spillway
Debris in Colorfalls spillway
1-877-80-PONDS
www.atlanticwatergardens.com
Possible Solution
Put in new batteries.
With unit plugged in and light
bar off, hold F Key until indi-
cator light blinks three times.
Confirm power to outlet.
Check all connections, ensure
cord is not cut or damaged.
Check all connections, ensure
cord is not cut or damaged.
Check connections, make sure
they are properly aligned.
Inspect all plumbing & plugs.
Ensure gasket in back plate
is in proper position.
Ensure screws are fully
tightened.
Clear debris from pump intake.
Inspect plumbing line and
clear any debris.
Refer to Maintenance section
on page 7.
Refer to Maintenance
section on page 7.