DEA SYSTEM NET230N Notice D'emploi Et Avertissements page 28

4
Selection operating with or without encoder
1. Scroll down the parameters with
sualise P029;
2. Access the parameter by pressing the
3. Acting on and
- d000=for operators with encoder;
- d001=for operators without encoder;
4. Confirm your choice by pressing the
again to P029).
5
Selection 1 or 2 operators functioning
1. Scroll down the parameters with
sualise P030;
2. Access the parameter by pressing the
3. Acting on and
- d001=for a single motor operating;
- d002=for 2 motors operating;
4. Confirm your choice by pressing the
again to P030).
6
Selection of direction of motion (only Type 00 and Type 03)
1. Scroll down the parameters with
until you visualise P063;
2. Access the parameter by pressing the
3. Acting on and
- d000=motor in standard position;
- d001=motor in inverted position;
4. Confirm your choice by pressing the
returns again to P063).
Warning: The parameter automatically reverses
the motors output open/close and any limit switch
input open/close.
7
How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. confirm by pressing the
3. by pressing (open) and
in the opening position and adjust the limit switch
cam so that it pushes the microswitch in that point;
Repeat adjusting the closing limit switch.
4. Confirm by pressing the
again P001).
WARNING If the Operator 2 is present, repeat the previous settings using P002.
26
and keys until you vi-
key;
keys, set:
key (display returns
and keys until you vi-
key;
keys, set:
key (display returns
and keys
key;
keys, set:
key (display
key;
(close), move the leaf
key (display shows
! IMPORTANT !