Important Safeguards; Special Instructions - Sunbeam HOSPITALITY 4211 Manuel D'emploi

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed including
the following:
R
• Use Iron only on a stable surface and for its intended use.
• To protect against risk of electric shock, do not immerse the iron in water or other liquids.
• T he Fabric Select Dial and Steam Lever should always be turned to off " " before plugging
or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and
pull to disconnect.
• A lways disconnect iron from electrical outlet when filling with water or emptying, cleaning
and when not in use or left unattended.
• D o not allow cord to touch hot surfaces. Let iron cool completely before cleaning or putting
away. When cool, clean only with damp cloth. Loop cord loosely around iron when storing.
• D o not operate iron with a damaged cord or if the iron has been dropped, damaged, or
leaking. To avoid the risk of electric shock, do not disassemble the iron. Contact your nearest
SUNBEAM authorized distributor. Incorrect reassembly can cause risk of electric shock when
™
the iron is used.
• T his appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• T he appliances are not intended to be operated by means of an external timer or separate
remote-control system.
• I ron is hot. Burns can occur from touching hot metal parts, hot water or steam. Use caution
when you turn a steam iron upside down – there may be hot water in the reservoir.
• I f the iron is not operating normally, disconnect from the power supply and call Customer
Service. Contact your nearest SUNBEAM
• Y our SUNBEAM™ iron is designed to rest on the heel rest. Do not leave the iron unattended
while it is plugged in. Do not set the iron on an unprotected or unstable surface, even if it is
on its heel rest.
• I f the power supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similar qualified person in order to avoid hazard.
• B EFORE USING IRON, remove any labels from soleplate and wipe any manufacturing
residue from soleplate using a soft cloth.
• To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
• Do not use an extension cord.
SAVE THESE INSTRUCTIONS
A I
EAD ll NSTRUcTIONS
S
PEcIAl
B
EFORE
authorized distributor.
™
I
NSTRUcTIONS
2
U
SE