Operation Instructions; Service And Replacement Parts; Warranty; Disposal - erba 13286 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Attach the stand (5) to the body of the hot glue gun.
Insert a glue stick into the glue stick feed (2) and push the feed trigger (4) to move the glue stick forward.
Plug the hot glue gun in, place it on a stable an non-flammable surface and wait a few minutes for it
to reach working temperature. The hot glue gun heats up to about 190°C so be careful not to tuch
the nozzle of the hot glue gun.
Clean your workpiece and apply the hot glue.
Press the two pieces together firmly and let it cool (3-5 minutes are usually enough).
You can use the hot glue gun on almost any material.

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
13286
Issue: 10/2017